Installing a Portable Polytunnel Greenhouse Part 2

Last week, we shared our new polytunnel greenhouse. We have been working on it, since it is nearing the time we usually start our seeds for our garden.

This week, we have begun working on the inside. We just need to purchase a heater and install our irrigation system and we will be good to go.

The inside currently looks like this:

Stable mats from Tractor Supply (I used two of them) and poly resin Muscle Tech garage shelves from Walmart. They snap together without tools and are very sturdy.

For the shelves, we purchased 5 5-tier Muscle Tech resin garage shelves. The fifth tier made them too tall so I reduced them to 4 tier and was able to make one more shelf out of them. This way, if these shelves don’t work for the greenhouse, I can repurpose them in our attic or garage. I wanted something with holes for drainage and ventilation that wasn’t expensive, wouldn’t rot or rust and could be used for something else if they didn’t work here.

We have also ordered a potting bench that hasn’t arrived yet.

We are looking at several different heaters and we are leaning toward this one:

And as for hydration:

We are planning to DIY something similar to this.

I can’t wait to show you the finished product! Check back next week!

Leave a Reply