DIY: A Swing Set Made for A Princess

How a few hours on a Saturday can lead to hours of fun

We have an aging redwood playset that my kids have had since my nine year old was two and a half. It’s been a lot of fun, but it is badly aged, and both kids are too big for it. I didn’t want to spend a ton of money on a new swingset, since both kids will likely age out of it in the not-too-distant future. But with Covid still on the rise, and the parks being too risky, we decided to DIY a simple yet sturdy swingset they would enjoy.

First, we bought four treated lumber 4X4x8 posts, a treated lumber 2x6x10 board and one treated lumber 4x6x10 post. We also bought metal swing set hardware from Amazon.

We started by inserting the 4X6 posts into the brackets to create both A-frames.

Repeat on both sides and then insert the 4X6x12 to make the top of the swing set. When all of your boards are inserted into the brackets, stand it up (with help- don’t do this alone) and tighten the bolts with an impact driver.
Then, make sure the ground under your swing set is completely level. If it isn’t, move it around to where you want it.
Cut your 2×6 in half and use wood screws to attach it to the 4×4 posts. This will stabilize it and create your A-frame.
Double check your lag screws and make sure everything is tightened down.
Install your swing hanging brackets. We used six of these and we measured before drilling.
Then, hang your swings and you are done! We reused the swings and trapeze bar from our old playset.

Looks like the tiny Lumbers approve!

Leave a Reply